Polaris TBM 200 LH - Manual (Page 19)

INSTALLATION, OPERATION AND MAINTENANCE MANUAL
POLARIS - SERIES TBM 200 LH ( 8” ) - TYPE PHO / PBO / PVO
19of 29
DOCUMENT NBR. : PED-010 REVISION: 1 EFFECTIVE
DATE: 08-24-2004
7.0 WET END INSTALLATION
Inspect and inventory all parts before you begin assembly. Clean all parts and
remove protective coatings as required. Inspect the motor module for any visual
damage paying particular attention to the shaft end and mechanical seal. Remove
any protective coatings from the shaft end and check to make sure that the tapped
hole in the end of the shaft and the key seat are free of any shavings and dirt. Prior
to the physical assembly of the wet end, familiarize yourself with all of the
components and the assembly sequence by reading the assembly instructions and
the enclosed explosion drawings. Based on your particular pump model and size
gather the necessary tools as per the following tool list.
TOOL REQUIREMENTS
Series TBM - 200 LH - Type “PHO”
- Allen wrenches 5/8” - 14 mm - 6 mm
- Plastic or Rubber Hammer
- “Never-Seize” or “Molykote”, “Locktite”
Series TBM - 200 LH - Types “PBO” and “PVO”
- Allen wrenches 5/8” - 14 mm – 8 mm - 5 mm
- Open ended wrench 2” or 51 mm
- Plastic or Rubber Hammer
- “Never-Seize” or “Molykote”, “Locktite”