Polaris TBM 200 LH - Manual (Page 4)

INSTALLATION, OPERATION AND MAINTENANCE MANUAL
POLARIS - SERIES TBM 200 LH ( 8” ) - TYPE PHO / PBO / PVO
4of 29
DOCUMENT NBR. : PED-010 REVISION: 1 EFFECTIVE
DATE: 08-24-2004
1.0 INTRODUCTION
Your new Series TBM pump has been designed and manufactured to perform for many years
with a minimum of maintenance. However, parts will wear and need replacing eventually. The
period between maintenance will greatly depend on the service and your maintenance program.
Series TBM pumps are heavy-duty Electro-submersible pumps featuring motor armatures with a
nominal service factor up to 2 depending on pump wet end and motor combination.
Pumps with standard motors are designed to operate completely submersed in liquids with pH
values from 6–14 and temperatures not exceeding 40
°C (104°F). Higher temperatures and / or
dry-running applications will require H or Super H insulation and / or an optional water jacket.
Motor modules of series TBM can be ordered in standard configuration
or as explosion proof units per
Class 1, Groups C&D, Temperature code T3C
UL Listed, File No. E10822
CSA Certified, File No. LR19467-15 (Frames 140,180,210,250 & 360)
CSA Certified, File No. LR19467-15 (Frame 320)
This manual has been compiled to help you minimize your maintenance and speed repairs when
required. Read and understand this manual.
Please provide the Serial Number of your equipment if additional manuals are needed.
WHEN ORDERING PARTS ALWAYS REFER TO PUMP SERIAL NUMBER.
THIS NUMBER IS FOUND ON THE NAMEPLATE ON THE PUMP.