Polaris TBM 200 LH - Manual (Page 5)

INSTALLATION, OPERATION AND MAINTENANCE MANUAL
POLARIS - SERIES TBM 200 LH ( 8” ) - TYPE PHO / PBO / PVO
5of 29
DOCUMENT NBR. : PED-010 REVISION: 1 EFFECTIVE
DATE: 08-24-2004
2.0 WARRANTIES
Seller warrants that the products covered by this contract conform to applicable drawings and
specifications accepted in writing by Seller, will be free from defects in material and workmanship,
will be merchantable and will perform in accordance with the detailed specifications accepted in
writing by Seller.
These warranties extend for a period of twelve (12) months from the date of purchase by Buyer.
Buyer’s exclusive remedy and Seller’s sole duty under these warranties is to repair or replace the
product. Normal wear and tear on Seller’s product shall not constitute a warranty defect.
THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, WHICH EXTEND BEYOND THOSE SET
FORTH ABOVE. THE WARRANTY OF MERCHANTABILITY IS LIMITED TO THE PERIOD SPECIFIED ABOVE.
These warranties are contingent upon the product being stored, installed, maintained, and
operated in accordance with good engineering practices and the instructions contained in the
Operating and Maintenance Manual. Failure to do so shall operate to void all warranties.
Seller’s total responsibility for damages whether arising in contract or tort arising out of or relating
to the performance of the product or the warranties hereunder shall be strictly limited to the
contract price for the product. In no event shall Seller be liable for any incidental or consequential
damages such as lost profits, loss of use of productive facilities or equipment, expenses or
damages incurred in reliance on the product's performance or lost production whether suffered by
buyer or any third party.
Seller warrants that the products comply with OSHA standards on drive guard design and
construction (if applicable) in effect at the time of manufacture and makes no other warranty with
respect to any other standards. Seller shall not be responsible for failure of parts to fit properly
due to deterioration of or modification to Buyer’s existing equipment for which such parts are
furnished.
Seller makes no warranty or guarantee that the product supplied hereunder will comply with the
performance of Buyer’s existing equipment.
Seller reserves the right to furnish substitutes for material not available or whose use is restricted.
The use of (a) non-OEM components or (b) non-OEM pump spare parts and/or (c) non-approved
modifications to the product and/or (d) failure to install a moisture detection relay and/or (e) failure
to connect the thermal overload protection wiring will operate to void all warranties.
We reserve the right to change the design, construction or material of any part without incurring
the obligation of installing such changes on pumps already delivered.