Polaris TBM 200 LH - Manual (Page 7)

INSTALLATION, OPERATION AND MAINTENANCE MANUAL
POLARIS - SERIES TBM 200 LH ( 8” ) - TYPE PHO / PBO / PVO
7of 29
DOCUMENT NBR. : PED-010 REVISION: 1 EFFECTIVE
DATE: 08-24-2004
4.0 INSTALLATION
4.1 RECEIVING INSPECTION
The unit must be inspected immediately upon arrival and any irregularities and damages
due to shipment must be reported to the carrier and POLARIS PUMPS. A copy of this
manual is included in the shipment. Put this manual a safe, accessible place for ready
reference when required. It is important that the entire contents of this manual are studied
before installation.
Pump parts and accessories may be packed inside shipping container, or attached to skids
in individual packages. Inspect all containers, crates and skids before discarding.
4.2 STORAGE
4.2.1 NEW PUMP AND EQUIPMENT STORAGE
If your new pump is to be stored for a long period before use, the following
procedures must be adhered to in order for POLARIS PUMPS to extend the normal
warranties.
Notify POLARIS PUMPS that the equipment is to be stored and that the storage
procedures will be followed. Notify POLARIS PUMPS when the equipment is to be
removed from storage and put into service.
Failure to notify POLARIS PUMPS will result in your warranty being void. Your new
pump will arrive ready for use. Close off all flush and cooling water inlet ports and
cooling water exhaust ports on water jackets. Suitable covers out of plywood or
plastic must be installed on the suction entrance and discharge to provide adequate
protection against dirt, dust and nesting animals. The main power and control cable
ends must be protected by means of suitable shrink-on boots or similar to prevent
the ingress of moisture during storage.
Equipment should be stored in a dry location and situated on an even surface with
no strains applied. If stored outdoors, the equipment must be covered with a
waterproof tarp secured to the equipment or skid.