Pitney Bowes K700 - Manual (Page 4)

ii
Declaration of Conformity According to FCC Rules Part 2 ,
Paragraph 2.1077
This device, K700 digital postage meter, complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation. Responsible party: Pitney Bowes, 1
Elmcroft Rd., Stamford, CT 06926-0700, (800) 522-0020.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may
cause interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
A shielded USB cable must used with this equipment to ensure
compliance with the limits. Use of a unshielded cable is prohibited.
FCC Part 68 Compliance of the K700 Modem
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the back of this equipment is
a label that contains, among other information, a product identifier in
the format US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
This equipment is designed to be connected to a Facility Interface
Code 02LS2 network with RJ11C network interface.
A plug and jack used to connect this equipment to the premises