Panasonic DBS 824 - Manual (Page 24)

System Features Auto Day Mode
Revised April 2000 DBS 824-3.0/3.2-700 1-7
• The digits used for the answer signal code are determined by the
requirements of the voice mail system.
• If the called extension does not answer and is forwarded to voice mail, the
DBS 824 sends a call forward ID code back to the voice mail system.
• During transmission of the answer signal code, other DTMF digits and
functions from the DBS 824 extension are ignored.
Auto Day Mode
(CPC-S and CPC-M)
Description
Auto Day Mode allows the DBS 824 to go into day mode automatically.
The DBS 824 can also be programmed to go into night mode automatically
(see “Night Service,” page 1-25).
If only one of the auto modes is turned on, the DAY/NIGHT1/NIGHT2
toggle key or the DAY, NIGHT1 or NIGHT2 key is used to turn off the auto
mode. For instance, if night mode has been activated automatically, the
attendant must press the DAY/NIGHT1/NIGHT2 key or DAY to go into day
mode. (Note: You must wait at least 3 minutes delay after the automatic mode
is activated before manually changing the mode. Otherwise the system will
immediately revert back to the automatic mode.)
If only one of the auto modes is turned on, the DAY/NIGHT1/NIGHT2
toggle key, NIGHT1 key, or NIGHT2 key can also be used to go into an auto
mode before the scheduled time. If auto day and both auto night modes are
turned on, themanual mode keys cannot be used.
Related Programming
• FF1 (System): Automatic Day Mode Start Time
• FF1 (System): Automatic Night Mode Start Time
• FF1 (System): Automatic Night2 Mode Start Time
Considerations
• If both auto modes are set, the starting times must differ by at least one
hour.