Pioneer Plasma Display Monitor 502MX - Manual (Page 104)

104
Menu Mode
8) ABL ON/OFF
Setting ABL: ON during playback of PC signals increases screen brightness.
If you set “ABL to ON” then the peak brightness will rise, and in addition the brightness of the pictures produced by
input signals will change.
If the change is unsatisfactory, set ABL: OFF.
Differences between ABL ON and OFF (illustration):
SCREEN
MAIN MENU
ALL RESET
PICTURE
POWER SAVE
3SET UP
BRIGHT : 0
COLOR : 0
TINT : 0
SHARP : 0
RESET
SET : NEXT
CONTRAST : 0
MENU : MENU OFF
5∞ 3 : SELECT
SET UP
SET : CHANGE
EXIT
5∞ 3 : SELECT
SETTING : PC
SIGNAL : RGB
TERMINAL : D-SUB
CLAMP : MODE 1
3ABL : OFF
V. ENHANCE : 0
H. ENHANCE : 0
ABL: OFF ABL: ON
The intensity levels of input signals are
faithfully reproduced. For images with relatively high overall brightness,
no significant change occurs (upper figure). But
for dimmer images, peak intensity images are
brighter when reproduced (lower figure).
1 Select SETUP. 2 Move the cursor to ABL and use the SET button
to change the current setting.
Pressing the SET button toggles between ON
and OFF.
Screen 2
Set-able condition : PC signals supplied.
Factory preset : ON