Pioneer Plasma Display Monitor 502MX - Manual (Page 54)

54
Table-top Stand: PDK-5001
Bolt (number required: four)
Washer (number required: four)
Hole rivet (number required: four)
Stand
Sheet
After mounting the stand to the display, fasten the assembly to the floor to prevent it from falling over.
2) Fastening to the floor
¶
Fasten the assembly to the floor using commercially-
available screws.
¶ Fasten the assembly to the floor using commercially-
available clamps.
Insert spacers of appropriate size
beneath the stand base.
CAUTION
An Alternative Method
1 Remove hole rivets from the rear of the display.
2 Mount the supplied turning-over protective bolts.
3 Using strings, mount the display/stand assembly to
the wall or to a column.
(Repeat the procedure for both the right and the left
sides.)
Use commercially-available strings and hooks.
3
2
1
4.4.5 Mounting to the main unit
1) Mounting procedures
1 Place the display face down, remove the hole rivets, and align the assembled stand to the display mount openings.
2 Secure the stand by tightening the washers and bolts with the supplied hexagonal wrench.
1. Lay a soft sheet beneath the display to protect it from scratches, etc.
2. The mount work should be conducted on a flat surface, such as a table.
3. Do not over-tighten bolts.
4. Align screw holes in the stand to the mount nuts found on the display as precisely as possible.
5. The unit weighs 40.3 kg., and its thinness makes it unstable. Therefore, unpacking and installation
should be performed by two or more persons.