Pioneer Plasma Display Monitor 502MX - Manual (Page 76)

76
Speaker System
UP
4.9.3 Mounting to the main unit
1) Installing procedure
Install the speaker according to the procedure (1)
through (3) below:The illustrations below show the
speaker (for right) to be mounted to the right of
the display.
Caution:
When the speaker is mounted to the display, the op-
eration panel of the display cannot be used. A remote
controller supplied to the display should be used.
(1) Affixing the mounting plate to the speaker
Note : Mounting plates should be attached to speakers
only when speakers are attached to the display.
(2) Installing the metal fixture on the speaker
• Washers M8 (
φ
25) are supplied for third-party metal
fixtures.
• Mount commercial fixtures by the two-point mounting
method to the mounting holes provided at the center
or bottom of the back of the speaker. These mounting
holes are at different levels. To make the hole levels
even, use additional washers until they are flush.
Hole rivet
Hexagon socket
screws
Plasma display
1. Make sure of right and left speakers by
confirming the indication of "Right" and
"Left" on the rear side. Set the mount-
ing plate to the corresponding speaker
so as to get a proper combination of
speaker and mounting plate.
2. Peel off two seals at the affixing plane
on the mounting plate.
3. Make sure of the position to be affixed
and affix the mounting plate to the side
of the speaker.
Set the mounting plate to 0.5 to 1cm be-
low the top of the speaker.
Mounting plate
Seal (2 places)
UP
UP
1. Since the upper metal fix-
tures are distinguished be-
tween right and left ones,
make sure of speakers and
right and left metal fixtures
properly before setting up.
2. Install the metal fixtures at
the position as shown in the
figure to the left.
Mounting metal
fixture (for upper
side)
Countersunk screw
Metal fixture (for lower side)
Mounting plate
(3) Installing the speaker to the side of the plasma
display
1. Remove the hole rivets (two places on a single side)
from the rear of the display (by turning the hole rivet
with a coin and so forth).
2. Make sure of right and left position by looking at the
indication of "Right" and "Left" on the rear side of the
speakers. With the "UP
»" indication placed upward,
install the upper metal fixture first and then the lower
one on the display.
(To make allowance for clearance correction, tempo-
rarily install the display.)
3. Adjust the position of the display so that the clearance
between the speakers and the display is even, then
fully tighten the screws.
• When you install the speakers, using
screws other than those provided may
cause the speakers to fall or malfunction.
Use only the screws provided for
installation.
• When the display is to be moved after
installing the speakers, do not hold the
speaker itself. Please move the display
by holding its lower side.
Caution