Pioneer Plasma Display Monitor 502MX - Manual (Page 67)

67
4.7.3 Assembling the mounting hardware and mounting the plasma display
1) Precautions before assembling
• Make sure you distinguish correctly between the vertical frames for right and left.
Both should be mounted so that their hexagonal sockets face outward.
• The horizontal frames should be mounted so that their smaller openings face the wall.
A total of eight openings are provided in the horizontal frames for wall-mounting. (A total of fourteen openings are
provided in the PDK-5006 itself.)
2) Assembly procedure
1 Loosen screw a and separate one end of the hook from the screw.
2 Hold the upper part of the vertical frame and open to an approximate width of 10 cm.
a
Loosen the screw until you can no longer
see its end through this opening.
The surface should
face the wall.
This side should face the wall.
(The smaller holes should
face the wall.) Hexagonal
wrench
Positioning the screw with a fingertip,
tighten the screw with a hexagonal
wrench.
Hexagonal sockets
facing outward.
Tiltable Plasma Display Wall-Mount Hardware: PDK-5006
Vertical frame (left)
Vertical frame (right)
Horizontal frame
Hexagonal socket head
flange bolt
Horizontal frame
3 Mount the horizontal frame to the vertical frames.
a
Hexagonal
socket head
flange bolt
Hexagonal socket head
flange bolt
Hexagonal
socket head
flange bolt