Paradyne Hotwire 7975 - Manual (Page 18)

Using the Asynchronous Terminal Interface
2-2 7975-A2-GB20-40 December 1998
Initiating an ATI Session
The Main Menu screen is displayed on the screen unless a login ID and
password is required or the ATI is already in use.
If security is enabled on the 7975 Standalone Termination Unit and you used
Telnet to access it directly (you did not log in through the MCC), the system
prompts you for a login ID and password.
О
О
ОО
ОО
Login Hotwire
Model: 7975
LOGIN
Login ID:
Enter Password:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions Exit
After you enter a valid login ID and password, the Main Menu appears. If you
enter an invalid login ID and password after three attempts, the Telnet session
closes or the terminal connection returns to an idle state. Refer to Chapter 7,
Security .
If the ATI is already in use, you will see a connection refused or
connection failed message (if you are using a Telnet session), or you will
see the IP address of the other user (if you are using the Management Serial
port).