Paradyne Hotwire 7975 - Manual (Page 91)

Configuration Option Tables
A-11 7975-A2-GB20-40 December 1998
Management and Communication Options Menu
The Management and Communication Options Menu includes the following:
H Telnet Sessions Options , Table A-5
H
Communication Protocol Options , Table A-6
H SNMP Traps Options , Table A-7
H
General SNMP Management Options , Table A-8
H SNMP NMS Security Options , Table A-9
Telnet Sessions Options
The Telnet Sessions Options (Table A-5) control whether a Telnet session is
allowed through an interconnected IP Network. If allowed, these options
determine what level of security to apply to the session to control access. Only
one Telnet session is allowed at a time. Initial values are determined by the
configuration you currently have loaded. To access the Telnet Sessions Options
screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Management and Communication
→
Telnet Session
Table A-5. Telnet Sessions Options (1 of 2)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies if the 7975 Termination Unit will respond to a Telnet session request from a
Telnet client on an interconnected IP network.
Enable – Allows Telnet sessions between the unit and a Telnet client.
Disable – No Telnet sessions allowed.
Telnet Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Used to secure access to the ATI through a Telnet session. Login IDs are created with a
password and access level. Refer to
Creating a Login in Chapter 7, Security.
Enable – Security is enabled. When access is attempted via Telnet, the user is
prompted for a Login ID and password.
Disable – No Login required for a Telnet session.