Paradyne Hotwire 7975 - Manual (Page 79)

8-1 7975-A2-GB20-40 December 1998
IP Addressing
8
Selecting an IP Addressing Scheme
The NTU’s network interface IP address is assigned through the peer IP address
of the LTU’s Network Interface menu. The NTU obtains the LTU’s IP address and
subnet mask when the PPP link is established over the EOC. The LTU IP
address and subnet mask are configured from the Communication Protocol
Options menu.
The 7975 Standalone Termination Unit is assigned an IP address and subnet
through the Peer IP address of the M/SDSL Network interface menu. Once the
address is assigned, you can use the 7975 Standalone Termination Unit’s ATI to
assign:
H
An IP address for each NMS. For SNMP IP Options, see Table A-7, SNMP
Traps Options , Table A-8, General SNMP Management Options , and
Table A-9, SNMP NMS Security Options , in Appendix A, Configuration Option
Tables.
H
An IP address for the TFTP server you wish to use to upload and download
configurations. See
Configuration Loader in Chapter 3, Initial Setup and
Configuration.
Review the following information in preparation for selecting an IP addressing
scheme.
H
Any legal host address is allowed for a given subnet. The address choice
within the subnet is arbitrary.
H A single route to a subnet is all that is needed to reach every device on a
subnet.