Paradyne Hotwire 7975 - Manual (Page 88)

Configuration Option Tables
A-8 7975-A2-GB20-40 December 1998
Communication Port
For Communication Port Options, refer to Table A-4. To access the
Communication Port screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Communication
Port
Table A-4. Communication Port (1 of 3)
Port Use
Possible Settings: Terminal, Net Link
Default Setting: Terminal
Specifies how the communications port is to be used.
Terminal – The communication port will be used for an Asynchronous terminal
interface.
Net Link – The communication port will be used as the network communication link to
an IP network or device.
Port Type
Possible Settings: Asynchronous, Synchronous
Default Setting: Asynchronous
When Port Use is set to Net Link, Port Type controls whether the communication port
will be asynchronous or synchronous.
Asynchronous – Configures the communication port for asynchronous communication.
Synchronous – Configures the communication port for synchronous communication.
NOTE: Peer IP Address and Circuit Identifier are not copied.
Data Rate
Possible Settings: 9.6, 14.4, 19.2, 28.8, 38.4
Default Setting: 9.6
Specifies the communication port baud rate.
9.6 – Communication port rate is 9600 bps.
14.4 – Communication port rate is 14400 bps.
19.2 – Communication port rate is 19200 bps.
28.8 – Communication port rate is 28800 bps.
38.4 – Communication port rate is 38400 bps.
Parity
Possible Settings: None, Odd, Even
Default Setting: None
Specifies the parity of the communication port.
None – No parity used.
Odd – Odd parity used.
Even – Even parity used.