Paradyne HOTWIRE 8310 MVL - Manual (Page 44)

8310 MVL and 8510 DSL Card Configuration
5-2 8000-A2-GB26-00 May 1998
NOTE:
Only a user who logs on to the Hotwire DSLAM with Administrative
permission can configure the DSL card.
"
Procedure
To configure card information, time/date, clear NVRAM, upload or download
configuration sets, download new firmware, or reset card:
1. Follow this menu sequence:
Configuration
→
Card Status (A-A)
2. The Card Status menu appears. Enter the desired value on each selected
screen and field as shown in Table 5-1 and press Return.
Table 5-1. Card Status Options (1 of 3)
Card Info (Card Information) A-A-A
Gives the user the ability to configure basic card-level information.
Card Name – 16 alphanumeric characters. Name assigned to the card.
Card Contact – 32 alphanumeric characters. Name or number of party responsible for
card.
Card Location – 16 alphanumeric characters. Location assigned to the card.
Local Control Terminal Port Mode – Standard/Extended (Default = Standard).
Standard is for USA keyboards; Extended is for European keyboards.
Remote Control Terminal Port Mode – Standard/Extended (Default = Standard).
Standard is for USA keyboards; Extended is for European keyboards.
Telnet daemon tcp port – 0–65536 (Default = 23). If you change this field, you need to
do a card reset.
Time/Date A-A-B
Gives the user the ability to configure the local time and date on the DSL card.
Local Time/Date – Enter the time in hh.mm format (am or pm). Enter the date in
mm/dd/yy format.
NOTE: At system boot time, the time on the DSL cards automatically synchronizes
with the MCC card.
NVRAM Clear A-A-C
Gives the user the ability to clear out the Non-Volatile RAM (NVRAM) in order to reuse
the card or to reconfigure the current card.
CAUTION: If you select yes on this screen, you will permanently remove most of
the configuration information you have stored on this card. The system
will perform a reset and return to the factory configuration.