Troubleshooting – Paradyne HOTWIRE 8310 MVL User Manual
Page 77
Diagnostics and Troubleshooting
7-3
8000-A2-GB26-00
May 1998
Troubleshooting
The status of each card in the Hotwire DSLAM is indicated on the Card Selection
screen (see
from the Hotwire Chassis Main Menu.
The status of each DSL card is indicated by codes being displayed in any of eight
positions to the right of the card selected. For example, if you select DSL card in
Slot 4, the following may be displayed:
4: 8510 _
M
R
U
U
U
X
X
Pos:
1
2
3
4
5
6
7 8
This display shows the following:
— There is an 8510 card in Slot 4
— Position 1 – no current test ( _ )
— Position 2 – major alarm is present (M)
— Position 3 – minor alarm is present (R)
— Position 4 – Ethernet link is up (U)
— Positions 5 and 6 – DSL ports 1 and 2 are up (U)
— Positions 7 and 8 – DSL ports 3 and 4 are disabled (X)
The following table explains the codes by position.
Position Display
Description
<card type>
MCC
1
T (Test mode)
Card currently in test mode
2
M (Major alarm)
Major alarm present on card
3
R (Minor alarm)
Minor alarm present on card
4
e (Ethernet)
Status of Ethernet link (U=UP, D=Down, X=Disabled)
5
d1 (DSL)*
Status of DSL card Port 1 (U=UP, D=Down, X=Disabled, or
H=Handshaking)
6
d2 (DSL)*
Status of DSL card Port 2 (U=UP, D=Down, X=Disabled, or
H=Handshaking)
7
d3 (DSL)*
Status of DSL card Port 3 (U=UP, D=Down, X=Disabled, or
H=Handshaking)
8
d4 (DSL)*
Status of DSL card Port 4 (U=UP, D=Down, X=Disabled, or
H=Handshaking)
9
w1 (WAN)*
Status of WAN link Port 1 (U=Up, D=Down, L=Loopback)
–
w2 (WAN)*
Status of WAN link Port 2 (U=Up, D=Down, L=Loopback)
–
w3 (WAN)*
Status of WAN link Port 3 (U=Up, D=Down, L=Loopback)
–
w4 (WAN)*
Status of WAN link Port 4 (U=Up, D=Down, L=Loopback)
* Not used for MCC cards.