Paradyne HOTWIRE 8310 MVL - Manual (Page 53)

8310 MVL and 8510 DSL Card Configuration
5-11 8000-A2-GB26-00 May 1998
Table 5-4. Bridge Options (2 of 2)
Client VLAN (Client) A-E-D
Gives the user the ability to configure static clients on VLANs. As there are up to 32
clients per port, multiple screens are required to completely configure the port.
For a list of VLAN IDs, press Ctrl-v.
DSL Port # – Enter the DSL port number (Default = 1).
Number of clients – Enter the number of clients to configure (0 – 32) (Default = none).
User – Enter the input number of the client (0 – 32) (Default = 0).
IP Address – Enter the client IP address in nnn.nnn.nnn.nnn format (Default = none).
There must be an entry in this field. Typically, all IP addresses in the same VLAN would
be on the same subnet.
NHR – Enter the IP address of the default next-hop router in nnn.nnn.nnn.nnn format
(Default = none).
VLAN – VLAN ID between 2 and 4094. (This field is read-only.)
Type – S = Static or D = Dynamic. (This field is read-only.)
ARP (Parameters and Add ARP Entry) A-E-E (A and B)
Select:
Parameters (A)
Gives the user the ability to configure general Address Resolution Protocol (ARP) cache
parameters.
Complete Entry Timeout (minutes) – Length of time that a complete entry remains
in the ARP Table before removal. A complete entry is one for which there is a MAC
address and a node has responded to the ARP request. Range = 1 to 200,000
minutes. (Default = 20)
Incomplete Entry Timeout (minutes) – Length of time in minutes that an
incomplete entry remains in the ARP table before being removed. (An incomplete
entry is an entry without a MAC address.) This is also the amount of time that a
packet will remain in the system while waiting for address resolution. Range = 1 to
255 minutes. (Default = 3)
NOTE: If you have made changes to this screen, you must do a card reset.
ARP Entry (Add ARP Entry) (B)
Gives the user the ability to add entries into the ARP cache.
Item – Enter 0 (zero) to add a new record.
IP Address – nnn.nnn.nnn.nnn format.
MAC Address – xx-xx-xx-xx-xx-xx format.
VLAN – Enter a VLAN ID between two and 4094 (Default = Null). There must be
an entry made in this field.
Trailer – Yes/No (Default = No).
Perm – Yes/No (Default = No). If you select yes for Perm and no to proxy, the ARP
entry will be saved in NVRAM (up to 32 entries). These are loaded when the card
reboots.
NOTE: For the Add ARP Entry screen, all other information entered is not stored in
the nonvolatile memory and will be lost when you reset the card.