Proxim AP-4000 - Manual (Page 177)

Command Line Interface (CLI) AP-4000 Series User Guide
Other Network Settings
177
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif <index> lbmaxclients <1–63>
Set the Multicast Rate (802.11a)
[Device-Name]>set wif 3 multrate <6, 12, 24 (Mbits/sec) >
Set the Multicast Rate (802.11b/g)
[Device-Name]>set wif 4 multrate <1,2,5.5,11 (Mbits/sec) >
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif 3 supermode <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif 3 turbo <enable/disable>
NOTE: Super mode must be enabled on the interface before Turbo mode can be enabled.
NOTE: Turbo mode and Mesh mode (either Mesh AP or Mesh Portal) can not be enabled on the same interface
simultaneously.
Configure Antenna Diversity
NOTE: When the AP-4900M is configured to use the 4.9 GHz Public Safety operational mode, antenna diversity is
disabled, and antenna 3 is statically configured for use. It is not configurable by the administrator. If an
operational mode other than 4.9 Public Safety is configured, the administrator may manually select which
antenna to use.
[Device-Name]>set wif 3 atdiversity <3, 4, 5(auto)> (see below)
[Device-Name]>set wif 4 atdiversity <1, 2, 5(auto)> (see below)
[Device-Name]>reboot