Proxim AP-4000 - Manual (Page 205)

Command Line Interface (CLI) AP-4000 Series User Guide
Parameter Tables
205
Syslog Parameters
The following parameters configure the Syslog settings.
NOTE: When Heartbeat is enabled, the AP periodically sends a message to the Syslog server to indicate that it is active.
The frequency with which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
Syslog Host Table
The table described below configures the Syslog hosts that will receive message from the AP. You can configure up to ten
Syslog hosts.
Name Type Value Access CLI Parameter
Syslog Group N/A R syslog
Syslog Status Integer enable
disable (default) RW syslogstatus
Syslog Port Octet String 514 R syslogport
Syslog Lowest Priority
Logged Integer 1 - 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG RW syslogpritolog
Heartbeat Status Integer enable (1)
disable (2) (default) RW sysloghbstatus
Heartbeat Interval
(seconds) Integer 1 - 604800 seconds;
900 sec. (default) RW sysloghbinterval
Name Type Value Access CLI Parameter
Syslog Host Table Table N/A R sysloghosttbl
Table Index Integer 1 - 10 N/A index
IP Address IpAddress User Defined RW ipaddr
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable
disable
delete RW status