Setup wizard instructions – Proxim AP-4000 User Manual
Page 36
Installation and Initialization
AP-4000 Series User Guide
Initialization
36
Setup Wizard Instructions
1. Click Setup Wizard to begin. The Setup Wizard supports the following navigation options:
•
Save & Next Button: Each Setup Wizard screen has a Save & Next button. Click this button to submit any
changes you made to the unit’s parameters and continue to the next page. The instructions below describe how to
navigate the Setup Wizard using the Save & Next buttons.
•
Navigation Panel: The Setup Wizard provides a navigation panel on the left-hand side of the screen. Click the
link that corresponds to the parameters you want to configure to be taken to that particular configuration screen.
Note that clicking a link in the navigation panel will not submit any changes you made to the unit’s configuration on
the current page.
•
Exit: The navigation panel also includes an Exit option. Click this link to close the Setup Wizard at any time.
CAUTION: If you exit from the Setup Wizard, any changes you submitted (by clicking the Save & Next button) up
to that point will be saved to the unit but will not take effect until it is rebooted.
2. Configure the System Configuration settings and click Save & Next. See
for more information.
3. Configure the Access Point’s Basic IP address settings, if necessary, and click Save & Next. See
for more information.
4. Assign the AP new passwords to prevent unauthorized access and click Save & Next. Each management interface
has its own password:
•
SNMP Read Password
•
SNMP Read-Write Password
•
CLI Password
•
HTTP (Web) Password
By default, each of these passwords is set to “public”. See
5. Configure the basic Wireless Interface Configuration settings:
•
Select the Operational Mode as follows and click Save & Next:
The Wireless-A interface operates only in 802.11a mode on the AP-4000/4000M and in either 802.11a mode or
4.9 GHz Public Safety mode on the AP-4900M. The Wireless-B interface can be configured to operate in the
following modes:
— 802.11b mode only: The radio uses the 802.11b standard only.
— 802.11g mode only: The radio is optimized to communicate with 802.11g devices. This setting will provide the
best results if this radio interface will only communicate with 802.11g devices.
— 802.11b/g mode: This is the default mode. Use this mode if you want to support a mix of 802.11b and 802.11g
devices.
— 802.11g-wifi: 802.11g-wifi has been defined for Wi-Fi testing purposes. It is not recommended for use in your
wireless network environment.
In general, you should use either 802.11g only mode (if you want to support 802.11g devices only) or 802.11b/g
mode to support a mix of 802.11b and 802.11g devices.
•
Configure the following available options and click Save & Next:
— Primary Network Name (SSID): Enter a Network Name (between 1 and 32 characters long) for the wireless
network. You must configure each wireless client to use this name as well. Note that the
AP-4000/4000M/4900M supports up to 16 SSIDs and VLANs per wireless interface (radio). Please see the
chapter for information on the detailed rules on configuring multiple SSIDs, VLANs,
and security profiles.
NOTE: Do not use quotation marks (single or double) in the Network Name; this will cause the AP to
misinterpret the name.