Proxim AP-4000 - Manual (Page 179)

Command Line Interface (CLI) AP-4000 Series User Guide
Other Network Settings
179
[Device-Name]>set telifbitmask <(see below)>
Choose from the following values:
Set Communication Ports
[Device-Name]>set httpport <HTTP port number (default is 80)>
[Device-Name]>set telport <Telnet port number (default is 23)>
Configure Secure Socket Layer (HTTPS)
Enabling SSL and configuring a passphrase allows encrypted Secure Socket Layer communications to the AP through
the HTTPS interface.
[Device-Name]>set sslstatus <enable/disable>
The user must change the SSL passphrase when uploading a new certificate/private key pair, which will have a
corresponding passphrase.
[Device-Name]>set sslpassphrase <SSL certificate passphrase>
[Device-Name]>show http (to view all HTTP configuration information including SSL.)
HTTP Group Parameters
=====================
httpifbitmask : 15
httppasswd : ********
httpport : 80
httphelplink : file:///C:/Program Files/ORiNOCO/AP4xxx/HTML/index.htm
httpsetupwiz : disable
sslstatus : enable
sslpassphrase : ********
Figure A-15 Result of “show HTTP” CLI Command
Set Telnet Session Timeouts
[Device-Name]>set tellogintout <time in seconds between 1 and 300 (default is 30)>
[Device-Name]>set telsessiontout <time in seconds between 1 and 36000 (default is 900)>
Configure Serial Port Interface
NOTE: To avoid unexpected performance issues, leave Flow Control at the default setting (none) unless you are sure
what this setting should be.
Interface Bitmask Description
0 or 2 = Disable (all interfaces) All management channels disabled
1 or 3 = Ethernet only
Ethernet only enabled
4 or 6 = Wireless A only Wireless A only enabled
8 or 10 = Wireless B only Wireless B only enabled
12 = Wireless A and Wireless B Wireless A and Wireless B enabled
13 or 15 = All interfaces
All management channels enabled