Proxim AP-4000 - Manual (Page 189)

Command Line Interface (CLI) AP-4000 Series User Guide
Parameter Tables
189
DHCP Server table for IP pools
NOTE: Set either End IP Address or Width (but not both) when creating an IP address pool.
DHCP Relay Group
The DHCP Relay Group allows you to enable or disable DHCP Relay Agent Status.
DHCP Relay Server Table
The DHCP Relay Server Table contains the commands to set the table entries. The AP supports the configuration of a
maximum of 10 server settings in the DHCP Relay Agents server table.
Name Type Value Access CLI Parameter
DHCP Server IP Address
Pool Table Table N/A R dhcpippooltbl
Table Index Integer User Defined N/A index
Start IP Address IpAddress User Defined RW startipaddr
End IP Address IpAddress User Defined RW endipaddr
Width Integer User Defined RW width
Default Lease Time
(optional) Integer32 > 0
86400 sec (default) RW defleasetm
Maximum Lease Time
(optional) Integer32 > 0
86400 sec (default) RW maxleasetm
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable (1)
disable (2)
delete (3) RW status
Name Type Value Access CLI Parameter
DHCP Relay Group Group N/A R dhcprelay
Status Integer enable
disable RW dhcprelaystatus
DHCP Relay Server
Table Table R dhcprelaytbl
Name Type Value Access CLI Parameter
DHCP Relay Server
Table Table N/A R dhcprelaytbl
DHCP Relay Server
Table Entry Index Integer32 1 - 10 R dhcprlyindex
DHCP Relay Server
Table Entry IP Address IpAddress User Defined RW dhcprlyipaddr
DHCP Relay Server
Table Entry Comment DisplayString User Defined RW dhcprlycmt
DHCP Relay Server
Table Entry Status Integer enable (1)
disable (2)
delete (3)
create (4) RW dhcprlystatus