Panasonic DVCPRO AJ-D250P - Manual (Page 13)

13
1
Set the accidental erasure prevention tab on the cassette tape to “recording,” and
insert the tape.
<Notes>
O
If recording prevention signals are included among the input signals, the input signals will not
be recorded properly.
O
Check that the SERVO lamp has lighted during recording. The image which is played back
will be disturbed if the lamp is flashing or off.
2
Press the STOP button to set the unit to the STOP mode.
3
Check that the REC INH lamp has gone off.
4
Selecting the video and audio input signals and adjusting the audio levels
4-1 Selecting the video and audio input signals
1 Connect the signals which are to be recorded.
2 Select the input signals using the INPUT SELECT switch on the front panel.
4-2 Adjusting the audio levels
1 Adjust the levels of the audio input signals.
The audio signals are recorded at the proper levels when the level controls
are at their center-click positions.
5
Press the PLAY button while holding down the REC button.
The REC and PLAY lamps light and recording commences.
6
Press the STOP button to end the recording.
The recording now ends, and the STOP mode is established.
Recording
Operation