Panasonic DVCPRO AJ-D250P - Manual (Page 33)

33
VIDEO menu
The underlining denotes the factory mode setting.
Setup Menus
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
600 VIDEO MODE
0000
0001 B/W
COLOR
For setting the recording and playback of the video signals.
0: When monochrome signals are used
1: When color signals are used
O
Set this item to the B/W mode when monochrome signals are to be
recorded or played back.
Set the item to the COLOR mode with regular color signals.
O
If color signals are recorded in the B/W mode, the pictures will be
abnormally colored when the signals are played back.
601 V-MUTE SEL
0000
0001 N-MUTE
LOW-RF
For selecting the processing to be performed in the event that LOW-RF has
occurred or the servo lock has been disengaged during playback.
0: The video signals are not muted.
1: The video signals are muted.
602 CC (F1) BLANK
0000
0001 BLANK
THRU
For selecting ON or OFF for the closed capture signals in the first field.
0: Forcible blanking
1: No blanking
603 CC (F2) BLANK
0000
0001 BLANK
THRU
For selecting ON or OFF for the closed capture signals in the second field.
0: Forcible blanking
1: No blanking
604 FREEZE SEL
0000
0001 FIELD
FRAME
For selecting the freeze mode of the still pictures in the PLAY PAUSE or
frame advance mode.
0: Field freeze
1: Frame freeze
605 IN FRM DET
0000
0001 FORCED
AUTO
For selecting the process for detecting the input signal frames.
0: The frames are detected at all times.
1: Frame detection is inhibited only with non-standard signals.
606 STD/NSTD SEL
0000
0001 AUTO
NSTD
For selecting the video signal processing.
0: The mode corresponding to the input is automatically established.
1: The non-standard mode is forcibly established.
607 VIN SETUP
0000
0001 THRU
CUT
For selecting the setup level when input composite signals are to be
converted into component signals and recorded.
0: The input signals are recorded as they are.
1: The signals are recorded after removing the 7.5% setup.
608 VOUT SETUP
0000
0001 THRU
ADD
For selecting the setup level when playback component signals are to be
converted into composite signals and output.
0: The playback signals are recorded as they are.
1: The signals are recorded after adding the 7.5% setup.