Panasonic DVCPRO AJ-D250P - Manual (Page 21)

21
Display position
The position where the superimposed display appears
can be changed using setup menu item No.002
“CHARA H-POS” and No.003 (CHARA V-POS).
(See page 28)
Superimposed Screens
<Note>
When the MODE button and the DATA+ button or
DATA– button are pressed, the counter display
appears temporarily while the buttons are held down
so that the setting can be checked.
Even while the MODE button is held down, settings
can still be performed using the DATA+ button or
DATA– button as the actual status is checked.
When the unit’s MONITOR OUT connector has been
connected to a TV monitor, the control signals, time
codes, etc. are displayed on the TV monitor screen as
abbreviations.
The display can be switched ON or OFF using the
setup menu item No. 000 setting. (See page 28)
Characters displayed
The background of the characters superimposed onto
the display can be changed using the setup menu
item No.004 “CHARA TYPE” setting. (See page 28)
TCR : : :
TV monitor
T TC CR R :: :: ::
TV monitor
TCR : : :
TV monitor
TCR : : :
TV monitor
TCR : : :
TV monitor
Abbreviation
CTL: control signal
TCR: time code playback value
UBR: user’s bit playback value
REM: remaining tape amount
No display:
Normally, no display
S: Appears with FAN STOP.
L: Appears with LOW RF.
N: Appears with NO RF.