Panasonic DVCPRO AJ-D250P - Manual (Page 7)

7
D Headphones jack
When headphones are connected to this jack, they
can be used to monitor the sound being recorded or
played back.
E Volume control
This is used to adjust the volume to the
headphones.
F Audio recording level controls
These controls are used to adjust the recording
level for PCM audio signals CH1 and CH2.
G REW button
When this button is pressed, the tape is rewound,
and the playback pictures can be monitored if
“TAPE” has been selected for the “S/F/R EE SEL”
setup menu item setting.
H STOP button
When this button is pressed, the tape stops
traveling, and the still picture can be monitored
when the “TAPE” setting has been selected for the
“S/F/R EE SEL” setup menu item.
In the stop mode, the drum still continues to rotate,
and the tape remains tightly wrapped around the
drum.
When the designated period of time has elapsed in
the stop mode, the unit is automatically set to the
standby OFF mode in order to protect the tape.
I FF button
When this button is pressed, the tape is fast-
forwarded, and the playback pictures can be
monitored if “TAPE” has been selected as the
“S/F/R EE SEL” setup menu item setting.
J PLAY button
When this button is pressed, playback is
commenced.
Recording is commenced when it is pressed
together with the REC button.
K PAUSE/STILL button
When this button is pressed during recording,
recording is stopped temporarily. When it is
pressed again, recording is resumed.
When this button is pressed during playback, the
still picture mode is established. When it is pressed
again, playback is resumed.
L REC button
Recording is commenced when this button is
pressed together with the PLAY button. When it is
pressed during playback or in the STOP mode or
standby OFF mode, the REC CHECK mode is
established. (See page 15)
M REMOTE connector
When the remote control (AG-A11) is plugged into
this connector, the unit can be operated at a
distance using the controls on the remote control
instead of the unit’s function buttons.
Keep the LOCAL/MENU/REMOTE switch at the
REMOTE position.
N COUNTER button
This button is used to switch the counter display.
CTL: Set here to display the tape timer (control
signal).
TC: Set here to display the time code.
UB: Set here to display the user’s bit.
Remaining tape:
Set here to display the amount of remaining
tape.
O RESET button
When this button is pressed in the CTL mode, the
counter display is reset to 00:00:00:00.
DATA + SET
PAUSE/STILL REC
RESET COUNTER
REMOTE
tte Recorder AJ-
Panasonic
(AG-A11)
Parts and Their Functions