Panasonic DVCPRO AJ-D250P - Manual (Page 51)

51
RS-232C
$ Media operation control commands
Sends data of computer Return data from VTR Description of command
[STX] HRE:m [ETX]
Parameters
m = S: STOP
R: REWIND
E: EJECT
M: REWIND and EJECT
[STX] HRE [ETX] Sets the VTR’s operation mode when the tape end position
is reached during recording.
<Note>
This command is ignored while a search control command
is being processed.
[STX] HTE:m [ETX]
Parameters
m = S: STOP
R: REWIND
E: EJECT
M: REWIND and EJECT
[STX] HTE [ETX] Sets the VTR’s operation mode when the tape end position
is reached during playback.
<Note>
This command is ignored while a search control command
is being processed.
[STX] HTI:m [ETX]
Parameters
m = S: STOP
W: REWIND
P: PLAY
M: PLAY PAUSE
[STX] HTI [ETX] Sets the VTR’s operation mode when the tape is inserted.
<Note>
This command is ignored while a search control command
is being processed.
$ Input/output control commands
Sends data of computer Return data from VTR Description of command
[STX] IEV:data [ETX]
Parameters
data = m1m2
m1 = 0
F: Designates the data of
bit 7 to bit 4.
m2 = 0 F: Designates the data of
bit 3 to bit 0.
[STX] IEV [ETX] Forcibly switches to the E-E (electric modulation to electric
playback) output.
When the V-V (VTR to VTR recording) output is the picture
output status, it is forcibly switched to the E-E output.
The forced E-E output is released and the normal status is
restored by IEV:00.
<Note>
This command is ignored while a search control command
is being processed.
Parameter m1 (HEX display) m2 (HEX display)
Bits supported BIT7 BIT6 BIT5 BIT4 BIT3
Switching data 0 0 0 0 AUDIO CH1
BIT2
AUDIO CH2
BIT1
VIDEO
BIT0
TC