Primera Technology 510212 User Manual

Page 20

Advertising
background image

Section 3: Getting Started

15

Digital Label Press 3 User’s Manual

Additional ribbon cartridges can be purchased to make switching between Press's

various print ribbons more convenient. Additional cutter blades can also be

purchased as needed. To remove these items from the inside of the printer, refer to

the following steps:

1. Press the Cover Release Button. Allow the cover to swing up and open.
2. With the cover open, you can see the Ribbon Cartridge.
3. Remove the shipping tape from both sides of the cartridge. Grasping each side

of the cartridge, lift it straight up and carefully remove it from the printer.

4. Remove the shipping tape fastening the Blade Holder to the Ribbon Cartridge

and separate the two items. Remove the Blade Holder from its packaging, and

refer to the next procedure for instructions on installing the Blade Holder into

Press's cutter.

THE CUTTER BLADE IS RAZOR-SHARP AND CAN EASILY CUT YOU. BE

EXTREMELY CAREFUL WHEN HANDLING THIS BLADE!

F. INSTALLING THE BLADE HOLDER

Refer to the following steps to install the Blade Holder into Press's cutter.

1. Open the Cutter Door by pulling up on the end of the cover closest to the paper

output tray.

2. Locate the black, plastic Cutter Arm. This is what holds the aluminum Blade

Holder in place.

CAUTION!

!

Blade Holder

Cutter Arm

Securing Knob

Impressa3.qxd 10/22/01 9:29 PM Page 15

Advertising