Primera Technology 510212 User Manual
Page 55
6. Select OK to begin contouring your image. You may see the following dialog
box appear when attempting to contour cut bitmap files. This slide bar sets the
sensitivity of the filter. If your sensitivity is high (i.e. 255) your cut line may
appear jagged as the filter picks up "noise" around the outside of an image.
This is common in lower resolution files as well as JPEGs. If the sensitivity is
too low (i.e. 100) the cut line may not follow the image and could overlap light
colored areas. A good general setting is 240.
7. Select OK to begin contouring your image. This process will take from just a
few seconds to a few minutes depending on the size and complexity of your
image. When the image is finished contouring, a dashed cut line will appear
around your image and both will be selected.
NOTE: If you imported a bitmap image, you may wish to select Show Bitmaps Outlines from the
View menu before proceeding. For more information on this option, see its explanation in
Part F of this section.
50 Section 7: Installing and Using the PressPrint Software for Windows
Digital Label Press 3 User’s Manual
Impressa3.qxd 10/22/01 9:29 PM Page 50