Primera Technology 510212 - Manual (Page 28)

Section 4: Ribbon and Print Media 23
Digital Label Press 3 User’s Manual
NOTE: Although the #300-Series Black UL-Recognized Ribbon provides maximum printquality
when printing onto #300-Series Polyesters, you may also achieve acceptable results by
using the variety of other #300-Series Resin Ribbons with the polyester materials. If doing
so, increase the Intensity setting within the printer driver setup window (see Section 6-D).
Note that print quality may vary when using the standard resin ribbons with the polyester
materials and, therefore, is not guaranteed.
IMPORTANT! Always seal print media in its original packaging and place on a smooth, flat
surface when not in use. Do not stack objects on top of the print media or place
more than 500 sheets in a single stack. Print media must not be exposed to excess
dust, heat, direct sunlight, or moisture and must not be allowed to curl or bend.
F. LOADING THE PRINT MEDIA ROLL INTO THE PRESS
Your press uses media on a proprietary roll. The core of the media roll contains a
chip that stores important information which is displayed on the LCD panel. This
system allows the user to identify the type of media on the roll as well as the
number of prints remaining on the roll by simply looking at the LCD display
panel.
Refer to the following steps to load print media into the supply tray:
1. Pull the Media Roll Release Lever downward.
Media Roll Release Lever
Impressa3.qxd 10/22/01 9:29 PM Page 23