Primera Technology 510212 - Manual (Page 76)

Section 8: Maintenance 71
Digital Label Press 3 User’s Manual
5. Unscrew and remove the top of the Blade Holder.
6. Tip the base of the holder upside down and remove the blade.
7. Insert the new blade into the base of the holder and replace the holder's screw-
on top.
8. Place the Blade Holder back into the Cutter Arm and retighten the gold-colored
Securing Knob by turning it toward the front of the printer. Tighten only until
the Blade Holder fits securely within the Cutter Arm. To verify proper
tightness, try rotating the Blade Holder clockwise within the Cutter Arm. If it
rotates, the Securing Knob needs to be further tightened. Do not over-tighten!
Impressa3.qxd 10/22/01 9:30 PM Page 71