Pinnacle Speakers DEKO500 - Manual (Page 149)

Deko500 User’s Guide
Menus
B ASELINE
Accept Baseline
Applies the baseline to the selected layer of the current graphic and
closes the Baseline Edit window.
Apply Baseline
Applies the baseline to the selected layer of the current graphic.
Bezier
Changes the selected point to a Bezier point. The section from the
previous point to this point is now a curve.
Cancel
Cancels changes to the Baseline and closes the Baseline Edit
window.
Cusp
Specifies no continuity between the Bezier curve control points on
either side of the selected point.
Delete Selected Point
Deletes the selected point from the baseline.
Draw Curve
Enables the curve drawing tool for drawing in the Baseline Edit
window.
Edit Curve
Enables the curve editing tool for changing the existing baseline in
the Baseline Edit window.
Insert Point
Activates the “insert point” mode, in which you can insert points
by clicking on the baseline where you wish to insert them.
Line to
Changes the selected point to a “line to” point. Deko500 draws a
straight line from the previous point to the line to point.
Loose Fit
Filters out “wobbles” caused by an unsteady drawing hand, for a
smoother curve.
Move to
Changes the selected point to a “move to” point. A move to point
begins a new section of the baseline.