Pinnacle Speakers DEKO500 - Manual (Page 32)

Cutting, Pasting, Finding, Replacing, and Moving Text 30
Deko500 User’s Guide
To delete or insert a point on a baseline:
1. If not already in the Baseline Edit mode, choose Edit Baseline
from the Layer menu.
2. In the Baseline menu, check Edit Curve.
3. Do one of the following:
Click the point you wish to delete, then choose Delete
Selected Point (Delete) from the Baseline menu.
Choose Insert Point (Insert) from the Baseline menu, then
click on the curve where you wish to insert the point.
To reverse the direction of the baseline:
1. If not already in the Baseline Edit mode, choose Edit Baseline
from the Layer menu.
2. In the Baseline menu, choose Reverse Baseline.
To change the type of a point on the baseline:
1. In the Baseline menu, check Edit Curve.
2. Click the point to select it.
3. In the Baseline menu, do one of the following:
Check Move To, for a point that begins a new section of the
baseline.
Check Line To, for a point connected to the previous point by
a straight line.
Check Bezier, for a point connected to the previous point by a
Bezier curve.
To adjust the continuity between two Bezier curves:
1. In the Baseline menu, check Edit Curve.
2. Click the point shared by the two curves.
3. In the Baseline menu, do one of the following:
Check Cusp for no continuity. The control points on either
side of the shared point move independently.
Check Smooth for C1 continuity.
Check Symmetric for C2 continuity.
To cancel changes to a baseline:
1. Do one of the following:
To cancel all changes and exit the Baseline Edit window,
choose Cancel from the Baseline menu.
If Undo is enabled, you can choose Undo (Ctrl+Z) from the
Edit menu, for each change you wish to undo.