Planet Technology 2-Bay SATA NAS RAID Server NAS-7200 User Manual
Page 57
Scandisk - running the Scandisk (Disk Check) program will check the file system, and correct
any errors found. This program should be run regularly. The Scandisk program will also run
automatically if an error condition is detected, such as an abnormal shutdown due to loss of
power.
Scandisk
This can have any of the following values:
z
N/A - No disk is available.
z
No Scanned - No Scandisk has been performed recently on this drive.
z
Scanning - Scandisk operation is in progress. The disk cannot be used
while a Scandisk is in progress. If required, use the "Stop" button to
terminate the Scandisk operation and gain access to data on the disk.
(To see the results of the Scandisk operation, use the "View Disk Log"
button.)
z
Completed - The last Scandisk operation has been completed. You can
use the "View Disk Log" button to view the results.
z Terminated - The last Scandisk operation was cancelled by the
Administrator before it was completed.
Schedule
Use these fields to set up a schedule to run Scandisk regularly, if desired.
The available options are:
z
Never - Scandisk will not be scheduled to run.
z
Every Day - select this to have scandisk run each day, at the specified
time.
z
Every Monday, Every Tuesday, ... - Select this to have the scandisk run
once per week, on the specified day.
Use the time fields (hour, minute, am/pm) to specify when the scandisk
operation should be performed.
56