Pioneer PDP 427CMX - Manual (Page 101)

101
Table Top Stand: PDK-TS07
4.5.5 Attaching the Stand to the Plasma Display
The Plasma Display is heavy, has no depth, and is
unstable, so be sure to have at least two people
assemble and install it.
Note
Insert the bolts in the holes vertically.
Place a sheet or protective cover to protect the display
from scratches or damage.
Assemble only with the Plasma Display lying flat on a
table or similar surface.
1 With the Plasma Display lying flat, insert and secure
the two Installation bolts 1 (M8 x 20 mm) in the
holes "a" located in center of the Plasma Display
housing.
At this point, tighten these bolts 1 only until the
threads are no longer visible when viewed from the
side (you will be unable to attach the display if the
bolts are screwed in completely).
Caution
Note
When laying down the Plasma Display, be careful so as
to not scratch or damage it.
Table. Regarding the stand pipe bolt holes when the
stand is used as a desktop stand
2 Hook the stand pipe holes B onto the bolt heads of
the installation bolts 1, then slide the stand
upwards to the Plasma Display until it engages the
installation bolts 1.
It slides no more than 19 mm (3/4 inch) because of
the structure of the stand.
3 Pass the installation bolts 2 (M8 x 40 mm) through
the stand pipe holes B’, and then screw them into
the main Plasma Display with the accessory
hexagonal wrench.
Move the stand so that the stand screw holes
and the nuts that connect the main display line
up correctly.
Be sure to tighten the bolts securely.
4 Tighten the installation bolts 1 firmly with the
accessory hexagonal wrench.
Be sure to tighten the bolts securely.
Plasma Display
Installation
bolt
1
Plasma Display
housing
Stop screwing
down the bolt
when the threads
are no longer
visible.
Installation bolt 1
(M8 x 20 mm)
Sheet
* Illustration depicts
50 inch display
model.
Holes "a"
(holes in center
of Plasma
Display)
B
Installation bolts 2
(M8 x 40 mm)
(Step 3)
Slide the stand
(Step 2)
Table top stand
Plasma Display model Bolt holes used with stand orientation
50 inch display model B, B'
43 inch display model A, A'
42 inch display model A, A'
Note
C and C ’ indicate bolt holes for optional components
that are sold separately.
[507CMX : 427CMX]