Pioneer PDP 427CMX - Manual (Page 175)

175
Menu Mode
5.3.4 Adjustment and setting in the Menu Mode
1) Power Management Setting
When no video signal (synchronizing signal) is detected, this function automatically sets the energy saving state to
save power.
• To disable the energy saving function, set to [OFF].
• When there is PC signal input:
To switch between the normal-operation state and the energy saving state is depended upon the presence of an
input signal, set ‘POWER MANAGEMENT’ to [ON].
Factory setting: OFF
Note
• To return from the energy saving state (by power management) to the normal operation state, operate the PC or
press the [INPUT] button on the remote control or main-control panel.
However, during SYNC ON G or composite SYNC input, operation does not return by simply operating the personal
computer. After operating the personal computer, press the [INPUT] button.
• The power consumption during power standby.
PDP-507CMX: 0.6 W
PDP-427CMX: 1.2 W
1 Select ‘SETUP‘.
2 Place the cursor over ‘POWER MANAGEMENT’ and
change the setting with the [SET] button.
Each time the [SET] button is pressed, the setting is
changed as shown below.
M E N U I N P U T 1
CHANGE SET EXIT MENU
S C R E E N S E T U P O P T I O N
P O W E R M G T. : O F F
S I G N A L F O R M AT
P I C T U R E
3 OFF
ON 2