Pioneer PDP 427CMX - Manual (Page 181)

181
Menu Mode
7) Orbiter Setting
This function gradually moves the display position of the screen periodically screen position is moved at random,
horizontally or vertically).
Setting ‘MODE1’ to ‘MODE3’ is effective in reducing screen burn when a still image is displayed.
Factory setting: OFF
1 Select ‘OPTION’.
2 Place the cursor on ‘SCREEN MGT.’ then press the [SET]
button.
2 Place the cursor on ‘ORBITER’ then press the [ 2/3]
buttons to change the settings.
Each time a [ 2/3] button is pressed, the setting changes
as shown below.
MODE1 ....... The size is reduced so the picture is
completely in the display area.
MODE2 ....... The size is increased so there are no black
bands in the display area.
MODE3 ....... It is displayed at the same size.
Note
• When ‘MODE1’ or ‘MODE2’ has been set, it moves smoothly.
• In ‘MODE3’, it moves in dot increments. The entire screen moves one dot horizontally or vertically approximately
every minute. The maximum movement is four dots.
• When it is set to ‘OFF’, the orbiter of the PIP subscreen is still ON.
The ‘ORBITER’ setting is common for all inputs.
Screen 2
M E N U I N P U T 1
ENTER SET EXIT MENU
S C R E E N S E T U P O P T I O N
L A N G U A G E
E N E R G Y S AV E
T I M E R S E T T I N G
S C R E E N M G T.
S P L I T F R E E Z E
A U T O S E T U P M O D E
A U T O F U N C T I O N
P I P D E T E C T
P I C T U R E
: S TA N D A R D
: I N A C T I V E
: O F F
: A C T I V E
: E N G L I S H
: O F F
Screen 3
SET SET EXIT MENU
S C R E E N M A N AG E M E N T
O R B I T E R
S O F T F O C U S
: O F F
: O F F
3 OFF
MODE3 2
2
MODE2 2
3
3 3
MODE1 2