Pioneer PDP 427CMX - Manual (Page 192)

192
Menu Mode [Applicable only when a PDA-5003/PDA-5004 is installed]
3) DNR (digital noise reduction) Setting
The DNR (digital noise reduction) setting can be changed to improve the S/N ratio when a video signal is input. The
setting should be performed for each input (INPUT1 to INPUT 5) and each signal.
Settable conditions: When there is video signal input
Factory setting: MIDDLE
1 Select ‘SETUP’.
2 Place the cursor over ‘DNR’ then press the [SET] button.
3 Each time a [ 2/3] button is pressed, the setting changes
as shown below.
Note
DNR is unavailable during 1080p signal or multi screen
display.
M E N U I N P U T 1
ENTER SET EXIT MENU
S C R E E N S E T U P O P T I O N P I C T U R E
: D I S A B L E
: M I D D L E
C O L O R T E M P. : M I D D L E
A U T O P O W E R O F F
D N R
: L O W
: O N M P E G N R
C T I
: O F F
: R G B P U R E C I N E M A
C O L O R D E C O D I N G
: A U T O C O L O R S Y S T E M
S I G N A L F O R M AT
Screen 2
: D N R M I D D L E
SET SET EXIT MENU
Screen 3
3 OFF 2
3 HIGH 2 3 MIDDLE 2 3 LOW 2