Pelco CM6700 - Manual (Page 22)

22 Pelco Manual C523M-H (6/05)
PROCEDURE METHOD
Enter Old Password.
Enter New Password.
Enter New Password
again.
Keypad
Keypad
Keypad
RETURN
SET PASSWORD
OLD PASSWORD *******
NEW PASSWORD *******
VERIFICATION *******
Table B. Programming the CM6700 Switching Control Unit (Continued)
Step 2
Function Action Result
Change a. Enter the Main Menu.
Password
b. Press 7.
c. Type the existing password and press ACK.
d. Type the new password and press ACK.
e. Type the new password again and press ACK.
f. Go to another step or press 9 to exit.
The Main Menu appears.
The Set Password screen appears. The first
asterisk (*) in the OLD PASSWORD field flashes.
The first asterisk (*) in the NEW PASSWORD field
flashes. If you make a mistake, you are prompted to
try again.
The first asterisk (*) in the VERIFICATION field
flashes.
The screen says “NEW PASSWORD ACCEPTED.”
If you make a mistake, you will be notified that the
new password does not match the verification
password.
After the new password is accepted, the Main Menu
appears.
NOTE: If you
change the
password and then
forget the new one,
you will have to
reset the system to
the factory defaults.
All system
programming will
be lost.
See the Trouble-
shooting section for
the system reset
procedure.