Proxim ORINOCO AP-2000 - Manual (Page 149)

149
Using the Command Line Interface (CLI)
Operational Mode
[Device-Name]>set wif <index> mode <see table>
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]>set wif <index> autochannel <enable/disable>
[Device-Name]>reboot 0
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Enable/Disable Interference Robustness (802.11b Only)
[Device-Name]>set wif <index> interrobust <enable/disable>
Enable/Disable Load Balancing (802.11b Only)
[Device-Name]>set wif <index> ldbalance <enable/disable>
Enable/Disable Medium Density Distribution (802.11b Only)
[Device-Name]>set wif <index> meddendistrib <enable/disable>
Set the Distance Between APs (802.11b Only)
[Device-Name]>set wif <index> distaps <large, medium, small, minicell, microcell>
[Device-Name]>reboot 0
NOTE
The distance between APs should not be approximated. It is calculated by means of a manual Site Survey, in
which an AP is set up and clients are tested throughout the area to determine signal strength and coverage,
and local limits such as physical interference are investigated. From these measurements the appropriate cell
size and density is determined, and the optimum distance between APs is calculated to suit your particular
business requirements.
mode Operational Mode
1 dot11b-only
2 dot11g-only
3 dot11bg
4 dot11a-only
5 dot11g-wifi