Proxim ORINOCO AP-2000 - Manual (Page 61)

61
Performing Advanced Configuration
Figure 4-13 DHCP Options: Setting the Boot Server Host Name
4. Add the Boot Server Host Name and Boot Filename parameters to the Active Options list.
5. Set the value of the Boot Server Host Name Parameter to the host name or IP Address of the TFTP server. For
example: 11.0.0.7.
Figure 4-14 DHCP Options: Setting the Boot Server Host Name
6. Set the value of the Bootfile Name parameter to the Configuration filename. For example: AP-Config
7. If using Syslog, set the Log server IP address (option 7, Log Servers).
8. Reboot the AP. When the AP reboots it receives the new configuration information and must reboot one additional
time. If a Syslog server was configured, the following messages can be observed on the Syslog server:
• AutoConfig for Dynamic IP
• TFTP server address and configuration filename
• AutoConfig Successful