Network parameters, Inventory management information, Ip configuration parameters – Proxim ORINOCO AP-2000 User Manual
Page 159: Using the command line interface (cli), Dns client for radius name resolution
159
Using the Command Line Interface (CLI)
Inventory Management Information
NOTE
The inventory management commands display advanced information about the AP’s installed components.
You may be asked to report this information to a representative if you contact customer support.
Network Parameters
IP Configuration Parameters
NOTE
The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipmask) or Default Gateway IP Address (ipgw) values can be entered.
DNS Client for RADIUS Name Resolution
Name
Type
Values
Access CLI Parameter
System Inventory Management
Subgroup
N/A
R
sysinvmgmt
Component Table
Subgroup
N/A
R
sysinvmgmtcmptbl
Component Interface Table
Subgroup
N/A
R
sysinvmgmtcmpiftbl
Name
Type
Values
Access CLI Parameter
Network
Group
N/A
R
network
IP Configuration
Group
N/A
R
ip (Note: The network and
ip parameters display the
same information)
IP Address
IpAddress
User Defined
RW
ipaddr
IP Mask
IpAddress
User Defined
RW
ipmask
Default Router IP Address
IpAddress
User Defined
RW
ipgw
Default TTL
Integer
User Defined (seconds)
64 (default)
RW
ipttl
Address Type
Integer
static
dynamic (default)
RW
ipaddrtype
Name
Type
Values
Access CLI Parameter
DNS Client
Group
N/A
R
dns
DNS Client status
Integer
enable
disable (default)
RW
dnsstatus
Primary DNS Server IP
Address
IpAddress
User Defined
RW
dnspridnsipaddr
Secondary DNS Server
IP Address
IpAddress
User Defined
RW
dnssecdnsipaddr
Default Domain Name
Integer32
User Defined (up to 254
characters)
RW
dnsdomainname