Proxim ORINOCO AP-2000 - Manual (Page 164)

164
Using the Command Line Interface (CLI)
802.11b/g Only Parameters
Note 1: Super Mode must be enabled first on the wireless interface before Turbo Mode can be enabled.
Wireless Distribution System (WDS) Parameters
Name Type Values Access CLI Parameter
Wireless Operational Mode Integer dot11b-only
dot11g-only
dot11bg (default)
dot11g-wifi RW mode
Operating Frequency Channel Integer 1 - 14; available
channels vary by
regulatory
domain/country; see
802.11g Channel
Frequencies
RW channel
Supported Data Rates Octet String See Transmit Rate ,
below
R suppdatarates
Transmit Rate Integer32 For 802.11b-only mode:
0 (auto fallback - default)
1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec
For 802.11g-only mode:
0 (auto fallback - default)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
For 802.11g-wifi and
802.11bg modes:
0 (auto fallback - default)
1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec RW txrate
Physical Layer Type Integer ERP (Extended Rate
Protocol) R phytype
SuperMode Integer enable
disable (default) RW supermode
TurboMode Integer enable
disable (default) RW turbomode
Name Type Values Access CLI Parameter
WDS Table Table N/A R wdstbl
Port Index Integer 3.1 - 3.6 (Wireless) R portindex
Status Integer enable, disable RW status
Partner MAC Address PhysAddress User Defined RW partnermacaddr