Pioneer SUPERTUNERD AVIC-N5 - Manual (Page 134)

Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn
HPF (high
pass filter) on. Only frequencies higher than
those in the selected range are output from
the front or rear speakers.
1 Touch [HPF] in Sound menu.
2 Touch [On] to turn high pass filter on.
To turn high pass filter off, touch [ Off].
3 Touch c or d to select cut-off fre-
quency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50
— 80 — 125 (Hz)
When [ Preout] (the subwoofer controller set-
ting in Initial menu) is [Sub. W], HPF function
is effective for front speakers only.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
p Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Touch [SLA] in Sound menu.
3 Touch [+] or [-] to adjust the source vo-
lume.
+4 to -4 is displayed as the source volume is
increased or decreased.
Sources are set to same source level adjust-
ment volume automatically.
! CD, ROM, DivX, S-DVD and M-DVD
! EXT-1 and EXT-2
! AV-1 and AV-2
! XM and SIRIUS
Setting Up the DVD/DivX
Player
Configure the DVD/DivX player.
DVD/DivX Setup adjustments
1
1 DVD/DivX setup menu display
1 Play the disc that contains DVD-Video
or DivX.
2 Press MENU button to change to AV
MENU.
3 Touch [Function].
4 Touch [DVD/DivX Setup].
5 Touch the desired function.
Setting the language
You can set a desired subtitle, audio and
menu language. If the selected language is re-
corded on the disc, subtitles, audio and menu
are displayed in that language.
1 Touch [Language] and then touch
[Subtitle Language], [Audio Language] or
[Menu Language].
Each language menu is displayed and the cur-
rently set language is selected.
2 Touch the desired language.
When you select [ Others], a language code
input display is shown. Input the four digit
code of the desired language then touch
[
Enter].
Customizing the AV Source Setting
En
134
Chapter
09