Pioneer SUPERTUNERD AVIC-N5 - Manual (Page 29)

! If there appear to be problems with the op-
eration of the system.
! When changing the combination of the
equipment.
! When adding/removing additional pro-
ducts that connect to the navigation sys-
tem.
p If you have connected other equipment (for
example, Bluetooth adapter) to this naviga-
tion system, be sure to reset that equip-
ment too.
DVD Map Discs for Your
Navigation System
Configuration of data recorded
on discs
The map for this navigation system is supplied
on two discs: one for the west and the other
for the east. Please set the disc to use accord-
ing to your destination or current location.
The areas recorded on each disc are as fol-
lows:
West area disc East area disc
p Removing the disc and inserting other disc
causes the navigation system to automati-
cally restart and reload the new route. (This
automatic
“Reroute” operation cannot be
canceled.)
Initial Use
If the initial learning is not complete, following
screen appears.
% If a message appears, touch [OK].
When the navigation system begins running
for the first time, the 3D Hybrid Sensor auto-
matically begins initial learning. Positioning is
performed solely by GPS satellites until the 3D
Hybrid Sensor initial learning is complete, so
the location of your vehicle may not be very ac-
curate. This is not an error. When the initial
learning is complete, the location of your vehi-
cle can be detected with high accuracy.
p [Shop Demo] is the demonstration used in
a store. Do not touch [ Shop Demo].
= If an error message appears during initial
learning, refer to Messages and how to
react to them on page 149.
Introduction
En
29
Chapter
01
Introduction