Pioneer SUPERTUNERD AVIC-N5 - Manual (Page 150)

System detected that the ver-
tical angle of the installation
has been changed. Learning
status for Gyro Sensor has
been initialized.
If the mounting angle of the naviga-
tion unit has been changed. The system initializes the sensor in order to
operate it with the maximum performance
and automatically starts re-learning.
System detected that the ver-
tical angle of the installation
exceeds the permission level.
Please install the navigation
unit correctly. The navigation system is installed
with an extreme angle exceeding
the limitation of the installation
angle. Confirm the installation angle. (The naviga-
tion system must be installed within the al-
lowed installation angle. For details refer to
Installation Manual.)
No data available at this time. If no data is available that can be
used with the XM tuner.
Wait for a while and try the operation again.
No XM signal. Please wait. While waiting for a response from
the XM tuner. Wait for a while and try the operation again.
You are in an area that cannot re-
ceive XM tuner reception. Move into an area that can receive XM tuner
reception.
Your current location provides very
poor reception. Change your location.
XM updating. Please wait. Service subscription is either XM
audio only or XM NavTraffic stand
alone. Since the GEX-P10XMT is capable of receiving
both XM audio and XM NavTraffic service, if
you are subscribed to only one or the other,
the system checks to see if you have added
another service to your account since you
last powered on the navigation system. When
you subscribe to both services, this message
will stop appearing when you turn the ignition
ON (ACC ON).
Radio is being updated with the lat-
est encryption code. Wait until the encryption code is fully up-
dated.
Updating The selected channel is not in-
cluded in your subscription. Select another channel.
Radio is being updated with the lat-
est encryption code. Wait until the encryption code is fully up-
dated.
Route calculation was not
possible. Route calculation has failed be-
cause of a malfunction of map data,
software, hardware or disc.
• Change the destination.
• Clean the disc.
• Consult the Pioneer Local dealer if this mes-
sage persists.
Route calculation was not
possible because the destina-
tion is too far. The destination is too far.
• Set a destination closer to the starting
point.
• Set one or more way points.
Route calculation was not
possible because the destina-
tion is too near. The destination or way point(s) are
too close. Set a destination or way point(s) farther from
the starting point.
Route calculation was not
possible due to traffic regula-
tions. • The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the route
calculation is hampered. • Set a destination and way point(s) outside
the CTR if you know where the restricted area
is.
• Try a destination or way point(s) away from
the currently set points to some extent.
• Drive your vehicle to an unrestricted area
and reset the destination and way point(s).
Appendix
En
150
Appendix