Pioneer SUPERTUNERD AVIC-N5 - Manual (Page 149)

Messages and how to react to them
The following messages may be displayed by your navigation system.
p There are occasions when you may see error messages other than those shown here. In such a case, follow the in-
structions given on the display.
Message When What to do (See)
Please insert the appropriate
disc.
ATTENTION This is not the ap-
propriate disc. Please insert
the appropriate disc. If you try to use a disc which is in-
compatible with this system. Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise
damaged. Insert a normal, round disc.
Irregular speed pulse signal is
detected. Please power off
the system and check the in-
stallation. After you have
checked, please re-boot the
system and press "OK". If the Navigation system does not re-
ceive the vehicle speed pulse. Consult your Pioneer dealer.
Speed pulse wire is not con-
nected. System will start to
learn without speed pulse.
Please keep in mind that accu-
racy is not fully ensured with-
out speed pulse. The speed signal input (pink lead
wire) of the power cable is not con-
nected. To operate with 3D hybrid mode, connect the
speed signal input (pink lead wire) of the
power cable correctly.
Although it can be operated with Simple hy-
brid mode without connecting the speed sig-
nal input, the precision of the positioning will
be less accurate.
Vibration is detected. Please
power off the system and
check the installation. After
you have checked, please re-
boot the system and press
"OK ". The navigation unit is installed in a
place where it may be affected by a
large vibration. Re-install the navigation unit in a place where
the unit will not be affected by vibration.
Direction of G sensor is not
correct. Please power off the
system and check the installa-
tion. After you have checked,
please re-boot the system and
press "OK". Direction of G sensor is set incor-
rectly. See the
“Installation Manual” and set the di-
rection of the navigation unit correctly.
Gyro Sensor is not working
properly. Please consult your
dealer or Pioneer service cen-
ter. Abnormal output is detected from
the Gyrosensor. Note down the error code shown on the
screen. Turn off the power, and then contact
your nearest Pioneer service facility.
This function is not available
now. The screen cannot be displayed with
Vehicle Dynamics Display. Because
the sensor has not been taught so
the sensor information cannot be
acquired. If the sensor learning status reaches the Sen-
sor Initializing status, the system is ready to
be used.
Appendix
En
149
Appendix
Appendix