Pioneer PDP-501MX - Manual (Page 13)

13
INPUT 4 Input
# INPUT 4 input terminal
Mini D-Sub 15-pin terminal for connection of RGB
signals
This terminal also supports component signals (settings
required in the menu screen).
This terminal supports Microsoft Plug & Play (VESA
DDC 1/2B).
(VESA is a registered trademark of the Video Electronics
Standards Association.)
INPUT 4 Output
$ INPUT 4 output terminal
Signals fed to the INPUT 4 input terminal # are sent
from this output terminal. No signal is sent when power
is switched off, or in standby status.
NOTE: When the unit is connected in a series using
this output terminal, up to five units can be
connected including the unit to which signals
are first input. If you use separate sync or
composite sync signal, over 4.8 Vp-p sync level
is necessary between the video source and the
first unit, under the condition of 2.2 k
Ω
input
impedance.
INPUT 1 Inputs
% S2 Video Input terminal (S terminal)
^ Video Input terminal (RCA jack)
& Video Input terminal (BNC terminal)
To prevent malfunctions and breakdowns, avoid
connecting the RCA jack and BNC terminal
simultaneously, since they are electrically connected
to each other inside the body.
INPUT 1 Output
* Video Output terminal
Signals fed to the INPUT 1 Video Input ^ or & are
sent from this output terminal. This terminal does not
carry signals received at the S-input terminal %. No
signal is available at this output terminal when power
is switched off, or in standby status.
NOTE: When the unit is connected in a series using
this output terminal, up to five units can be
connected including the unit to which signals
are first input.
Controls and Connectors
INPUT 2 Input
Component video input terminals composed of three RCA
jacks ( to _.
( Y Input: 75 Ω
) CB and PB Input: 75 Ω
_ CR and PR Input: 75 Ω
Control
+ Combination Input and Output terminals
Used for simultaneous control of multiple units
(Refer to 5.6 Combination Connections)
NOTE: No ABL linkage function is provided. These
terminals are incompatible with multi-
projections such as the RM-V4800V.
¡ Control connector (conforming to RS-232C)
Used to make adjustments or settings externally
™ SR IN/OUT terminals
For SR connection (refer to the operation manual) to
AV units from Pioneer
NOTE: This product does not support RU-V107 wired
remote control units.