Pioneer PDP-501MX - Manual (Page 77)

77
Menu Mode
5) Setting Up Peripheral Equipment
A unit function automatically identifies signals from a PC and signals from DVD players or other AV units. But
depending on the signal, this function may not always work. In such cases, you must set the input settings manually.
This setting needs to be made separately for INPUT 3 and INPUT 4.
Examples: • When connecting AV units
= INPUT SETTING: VIDEO
• When connecting PCs =[INPUT SETTING: PC
1 Select SET UP. 2 Move the cursor to INPUT SETTING and change
the setting using the SET button.
Pressing the SET button toggles the setting
between VIDEO and PC.
Screen 1 Screen 2
• Conditions that allow adjustments: When signals for INPUT 3 or 4 are not automatically identified.
• Factory preset: INPUT 3 to PC
INPUT 4 to PC
NOTE: • INPUT 2 is dedicated to component video signals and set to VIDEO. It does not support PC signals.
• 31.5 kHz x 60 Hx or 15.7 kHz x 60 Hz signals in INPUT 3/4 mode. (The unit does not automatically configure
itself).
MAIN MENU
V MEMORY
SCREEN
RESET
AUTO POWER OFF
3SET UP
PICTURE
MENU : MENU OFF
5 : SEL.
SET : NEXT
SET UP
SIGNAL : RGB
CLAMP : MODE1
3INPUT SETTING : VIDEO
EXIT
5∞ : SEL. SET : CHANGE