Pioneer PDP-501MX - Manual (Page 55)

55
Speaker System: PDP-S02-LR
4.6.2 Mounting to the main unit
Two mounting methods are available. Proceed as follows.
1 Mounting to the sides of the display
• The figure illustrates how to mount the speaker to the
right side of the display.
1. Remove the lower two hole rivets from the rear of the
display. (The hole rivet can be removed using a coin or
other device.)
2. Mount the supplied mounting components to the
speakers. (Take care to keep the protective cushioning
from peeling off.)
3. Find the left and right speakers (check for “Left” and
“Right” marks) and mount the speakers to the display,
with the cushioning facing the display and the “UP”
mark up, by first tightening the lower, then the upper
mounting components. (At this point, the mounting
components are only tightened temporarily.)
4. Securely tighten the flat screws to mount the mounting
components firmly to the display, while positioning
mounting components to ensure even clearance
between the speaker and the display.
• The use of screws other than those supplied may
prevent secure installation or correct operation. Use
only the supplied mount screws.
• If you must move the display after the speakers have
been mounted, grasp the lower part of the display
instead of the speakers.
2 Mounting using commercially-available mounting
components
• This speaker system comes with M8 washers (ø25)
for mounting the system using commercially-available
mounting components.
• Use either the center set of two mount openings or
the lower set, which is designed for use with
commercially-available mounting components. The two
mount openings for either set are not level; the supplied
washer provides the necessary compensation.
UP
UP
UP
[PDP-502] [PDP-501MX/PDP-V501X]
Cushion
Mount
components
Flat screw
Hexagonal
screw
Hole rivet
Washer (ø15)
Secure at either pair of
points, with the washer
fitted to the lower
opening to level it with
the upper opening.
1 Pare the insulation
from the ends of the
cable and twist the
bare wires.
2 Press the level and insert
the ends of the twisted
wires into the proper
openings. Release the
lever.
Washer, M8
(ø25)
Connection to a stereo amplifier
1. Switch off power to the stereo amp.
2. Use the supplied speaker cable to connect the speaker
input to the amp output. The red input terminal (the
terminal at the right in the illustration) is positive (+).
The black terminal (at the left in the illustration) is
negative (–).
Negative ·
terminal
Positive ª
terminal
To negative ·
terminal
To positive ª
terminal
(Output from the stereo amp)